WTAIN-M Programmable Analog Input

WTAIN-M Programmable Analog Input

  • £113.83
Shipping calculated at checkout.

Only 4 left!


Connects to the RS-232 serial port or USB adapter on a PC, laptop, or other host. Simple command strings sent from the host will read the voltage at the input channels. The value returned to the host can be shown as a voltage, or programmed by the user for any other engineering units desired. The readings can also contain a decimal point if needed, the position programmable by the user. Interface directly with pressure transducers, load cells, strain gages, temperature sensors, 4-20 mA devices, potentiometers, etc. Ideal for direct data acquisition applications without requiring data conversions at the output.


  • 4 differential input channels with a ±10V common mode range and protection to ±40V.
  • 3 factory calibrated modes: +10.000 V to -8.000 V, ±600.0 mV, and ±600.00 mV.
  • 2 user programmable modes which display readings in direct engineering units of choice.
  • User programmable decimal point position.
  • 20-bit A/D converter provides resolutions down to 1.4 µV (user programmable modes).
  • 8-times averaging smoothes out readings.
  • 5-Volt excitation output for bridge sensors.
  • Software calibrated; no trim-pots to adjust.
  • All user configuration and calibration data stored in non-volatile memory.
  • DIP switch addressable; stack up to 32 modules on the same serial port for 128 differential input channels.
  • Industry standard RS-232 interface. Meets all EIA/TIA-232E and V.28 specifications.
  • Wide power supply range (15 to 30 VDC).
SKU: hc00151