
BAE0911 - Programmable 22 i/o 1-Wire slave device
Main Features
22 i/o pins allows mixed functions selectable among
- 22 pio TTL digital input/output with changed latch bit
- 6 up/down 32bit encoders
- Four 16 bit PWM (pulse width modulation) from 0.1Hz to 10MHz
- Four 16 bit capture input shared with PWM
- 16 ADC inputs at 10 bit resolution (0 to 5V range)
- 6 interrupt based 32bit counters (up to 5KHz)
- 12 additional 32bit counters (up to 100Hz)
- One analog comparator with output on compare
Extended connectivity
- One buffered TTL serial port (RX/TX) baud rate from 50 to 1000.000 bauds
- I²C master interface up to 1Mbit/s
- SPI master interface (aka four wires) up to 1MHz
- Standard speed 1-Wire slave interface with unique ROM serial number
Advanced features
- Firmware upgradable via 1-wire bus.
- The chip firmware is contained in FLASH and can be upgraded directly from the 1-wire bus.
- Automation Engine: allows embedding Basic-like programs for autonomous behaviour
- Calibrated 32 bit counter clock (typical deviation 0.5%)
- Integrated watchdog monitoring with automatic reset
- All PIO has configurable internal pull-up resistor (PIO0..PIO7 have also pull-down)
- 6 fast counters are configurable on rising/falling edge
- 12 slow counters on falling edge only
- 32Kbit of user flash storage (8 pages of 512 bytes)
- 92 bytes of user register
- 4x 92 bytes of RAM dedicated for Automation user programs
- ADC is working in continuous conversion mode (no start conversion command, no delays)
- 32 distinct countdown registers for timer behavior in AE
- SDcard support up to 2GB for direct access to 512bytes sectors
Compatibility with 1-wire protocol
- Standard speed operation: protocol implemented with low latency interrupts in background.
- Support every standard ROM commands: read rom, match rom, search rom, skip rom, resume rom and conditional search
- Unique serial number
- Family code 0xFC: with extended identification commands: read_type & read_version.
Physical characteristics
- Single chip microcontroller based solution in an 28-pin SOIC.
- 5.0V supply voltage, 10mA typical consumption
- 40MHz operation
- based on Freescale MC9S08SH16CWL microcontroller
Full datasheet available here